17.5.9 Packet Tracer – Interpret show Command Output Instructor Version
Topology
Objectives
Part 1: Analyze Show Command Output
Part 2: Reflection Questions
Background
This activity is designed to reinforce the use of router show commands. You are not required to configure, but rather to examine the output of several show commands. This activity does not automatically provide a score.
Instructions
Part 1: Analyze Show Command Output
a. To connect to ISPRouter, Click ISP PC, then the Desktop tab, followed by Terminal.
b. Enter privileged EXEC mode.
c. Use the following show commands to answer the Reflection Questions in Part 2.
Note: If a command pauses with the -–More—prompt, make certain to hit the spacebar until the ISPRouter# prompt appears in order to obtain all of the command output.
show arp show flash: show ip route show interfaces show ip interface brief show protocols show users show version
Part 2: Reflection Questions
1. Which commands can you use to determine the IP address and network prefix of interfaces?
show ip route, show interfaces, show protocols (before IOS 15, the show ip route command did not display the IP address of the interfaces)
2. Which command provides the IP address and interface assignment, but not the network prefix?
show ip interface brief
3. Which commands would you use to determine if an interface is up?
show interfaces, show ip interface brief, show protocols
4. You need to determine the IOS version that is running on a router. Which command will give you this information?
show version
5. Which commands provide information about the addresses of the router interfaces?
show arp, show interfaces, show ip route, show ip interface brief, show protocols
6. You are considering an IOS upgrade and need to determine if router flash can hold the new IOS. Which commands provide information about the amount of Flash memory available?
show version, show flash
7. You need to adjust a router configuration, but you suspect that a colleague may also be working on the router from another location. Which command provides information about the lines being used for configuration or device monitoring?
show users
8. You have been asked to check the performance of a device interface. Which command provides traffic statistics for router interfaces?
show interfaces
9. Customers are complaining that they cannot reach a server that they use for file storage. You suspect that the network may have become unreachable due to a recent upgrade. Which command provides information about the paths that are available for network traffic?
show ip route
10. Which interfaces are currently active on the ISP Router?
GigabitEthernet 0/0, Serial 0/0/1
End of document
